STS Industrial - Bolts & Screws

 

FIG 104 ADJUSTABLE SWIVEL SPLIT-TYPE RING

APPLICATION

The Figure 104 Adjustable Swivel Ring – Split Ring Type is recommended for suspension of non-insulated stationary pipe lines.

SIZE RANGE

3/4″ through 8″

MATERIAL

Malleable Iron, Carbon Steel – Plain or Galvanized

MAX TEMP

450° F

COMPLIANCE

ASME B31.1, Federal Specification A-A-1192A (Type 6), WW-H-171-E (Type 6), ANSI/MSS-SP-69  and MSS SP-58 (Type 16).

NOTE

Labor saving features in installation completely outweigh slight additional cost. Hanger may be installed prior to suspension of pipe. Off-center hinge provides seating for pipe during installation. Wedge-type locking pin is inseparably cast into hinged section, sizes 2 1/2″ and larger. Adjustable swivel ring is self-locking to prevent loosening due to vibration; maintains proper pitch of pipe. Wire retaining ring prevents separation of swivel shank from pipe ring before installation.

Fig 104 Adjustable Swivel Ring

  • DIMENSIONS & LOADS:

    Fig 104 Adjustable Swivel Ring Drawing, Loads, Weights, and Dimensions

  • PRODUCT CROSS REFERENCE¹:

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 104

    Carpenter & Paterson Figure 240
    Piping Technology
    PHD Figure 505
    B-LINE Figure B3171

    ¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in size and shape. The Product Cross Reference is a guide for the product application only.

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware