STS Industrial - Bolts & Screws

 

FIG 108 SPLIT PIPE RING

APPLICATION

The Figure 108 Split Pipe Ring is recommended for the suspension of non-insulated stationary pipe lines or conduit. May be used with rod socket Fig 110R or turnbuckle adjuster Fig 114.

SIZE RANGE

3/8″ through 8″

MATERIAL

Malleable Iron

MAX TEMP

450° F

COMPLIANCE

ASME B31.1, Federal Specification A-A-1192A (Type 11), WW-H-171-E (Type 11), ANSI/MSS-SP-69 and MSS SP-25 (Type 11).

NOTE

Permits installation before or after pipe is in place. Provides economical installation. Permits use of universally adaptable parts.

Fig 108 Split Pipe Ring

  • DIMENSIONS & LOADS:

    Fig 108 Split Pipe Ring Drawing

    Fig 108 Split Pipe Ring Loads, Weights, and Dimensions

  • PRODUCT CROSS REFERENCE¹:

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 108

    Carpenter & Paterson Figure 34
    Piping Technology
    PHD Figure 500
    B-LINE Figure B3173

    ¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in size and shape. The Product Cross Reference is a guide for the product application only.

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware