STS Industrial - Bolts & Screws

 

FIG 126 ONE HOLE CLAMP

APPLICATION

The Figure 126 One Hole Clamp is designed for the support of standard conduit, cable, and steel pipe on walls or sides of beams. Not recommended for use horizontally on ceilings, bottoms of beams, and similar installations since the factor of safety is greatly reduced when used in this type of application.

SIZE RANGE

3/8″ through 4″

MATERIAL

Malleable Iron

MAX TEMP

Plain 450° F, Galvanized 450° F

NOTE

Specify nominal pipe diameter or conduit size, or O.D. of lead cable with which the clamp is to be used.

Fig 126 One Hole Clamp

  • DIMENSIONS & LOADS:

    Fig 126 One Hole Clamp Drawing

    Fig 126 One Hole Clamp Loads, Weights, and Dimensions

  • PRODUCT CROSS REFERENCE¹:

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 126

    Carpenter & Paterson Figure 237
    Piping Technology
    PHD Figure 835
    B-LINE Figure B2302

    ¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in size and shape. The Product Cross Reference is a guide for the product application only.

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware