STS Industrial - Bolts & Screws

 

FIG 138R EXTENSION SPLIT PIPE CLAMP (ROD THREADED)

APPLICATION

The Figure 138R Rod Threaded Extension Split Pipe Clamp is recommended for non-insulated stationary pipe lines.

SIZE RANGE

3/8″ through 3″

MATERIAL

Malleable Iron, Plain or Galvanized

MAX TEMP

450° F

COMPLIANCE

ASME B31.1, Federal Specification A-A-1192A (Type 12), WW-H-171-E (Type 25), ANSI/MSS-SP-69 and MSS SP-25 (Type 12).

NOTE

Rapid installation assured by hinged design and single closure screw. When used with nipple, this clamp is particularly adaptive for use on refrigeration or compressor piping subject to vibration. Interior design provides firm grip on pipe. Inside of ring tapered to prevent entrapment or condensed moisture.

Fig 138R Extension Split Pipe Clamp

  • DIMENSIONS & LOADS:

    Fig 138R Extension Split Pipe Clamp Drawing

    Fig 138R Extension Split Pipe Clamp Loads, Weights, and Dimensions

  • PRODUCT CROSS REFERENCE¹:

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 138R

    Carpenter & Paterson
    Piping Technology
    PHD Figure 508R
    B-LINE Figure B3198H

    ¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in size and shape. The Product Cross Reference is a guide for the product application only.

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware