STS Industrial - Bolts & Screws

 

FIG 167 INSULATION PROTECTION SADDLE

APPLICATION

The Figure 167 Insulation Protection Saddle is recommended for outside of foam or fiberglass insulation for distribution of loads to preclude crushing of insulation without breaking the vapor barrier.

SIZE RANGE

1/2″ through 24″ pipe with up to 2″ thick insulation

MATERIAL

Carbon Steel

FINISH

Galvanized

COMPLIANCE

ASME B31.1, Federal Specification A-A-1192A (Type 40), WW-H-171-E (Type 41), ANSI/MSS SP-69 and MSS SP-58 (Type 40).

NOTE

To order, specify size (see “Size Selection” below), figure number and name. Data applicable to shields for thicker insulation or larger pipe sizes is available.For protection shields to be used in conjunction with pipe rolls, see Pipe Protection Saddles.

Fig 167 Pipe Shield

  • INSTALLATION DRAWINGS:

    Fig 167 Pipe Shield Installation Drawing 1

    Fig 167 Pipe Shield Installation Drawing

    Fig 167 Pipe Shield Installation Drawing 2

    The above drawings represent some common installations of the pipe support represented on this page. Installation types and configurations are not limited to the drawings above, but should always follow the manufacturers guidelines for application and installation.

  • DIMENSIONS & LOADS:

    Fig 167 Pipe Shield Drawing

    Fig 167 Pipe Shield Loads, Weights, and Dimensions

  • NOMINAL PIPE:

    Fig 167 Pipe Shield Selection for Nominal Pipe

    COPPER TUBING:

    Fig 167 Pipe Shield Selection for Copper Tubing

    Note: As actual foam or fiberglass insulation thicknesses vary, verify that the radius of the selected shield is suitable for the required application. Shields are designed for a maximum span of 10 feet on 15 psi compressive strength insulation. For compressive strengths greater than 4 psi, spans may be increased proportionately up to maximum allowable for steel pipe. Refer to MSS-SP-69 for specific guidelines on compressive strength and maximum span.

  • PRODUCT CROSS REFERENCE¹:

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 167

    Carpenter & Paterson Figure 265P
    Piping Technology Figure 183
    PHD Figure 170
    B-LINE Figure B3151

    ¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in size and shape. The Product Cross Reference is a guide for the product application only.

  • Also Known As

    Pipe Saddle

    Pipe Shield

    Insulation Shield

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware