STS Industrial - Bolts & Screws

 

FIG 178 SPRING CUSHION HANGER

APPLICATION

The Figure 178 Spring Cushion Hanger is generally used with the Fig 171 Pipe Roll as shown in the photo to the right. It is recommended for installations where formal load and movement calculations are not required, or calculated movement does not exceed 1/4″. The Fig 178 consists of a set of two springs and four retainers only (no pipe roll).

FINISH

Plain retainers, painted springs.

MATERIAL

Cast Iron Retainers

MAX TEMP

450° F at Roller

COMPLIANCE

Federal Specification A-A-1192A (Type 49), WW-H-171-E (Type 50), ANSI/MSS-SP-69 and MSS SP-58 (Type 49).

NOTE

To order, specify figure number, name, and rod size. If used with Fig 171 single pipe roll, pipe roll must be purchased separately. The retainers are casted to the dimensions as shown, but center hole can be drilled or reamed to satisfy the hanger rod required, up to the max rod size.

Fig 178 Spring Cushion Hanger

  • DIMENSIONS & LOADS:

    Fig 178 Spring Cushion Hanger Drawing

    Fig 178 Spring Cushion Hanger Loads, Weights, and Dimensions

  • PRODUCT CROSS REFERENCE¹:

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 178

    Carpenter & Paterson Figure 478
    Piping Technology
    PHD
    B-LINE Figure B3264

    ¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in size and shape. The Product Cross Reference is a guide for the product application only.

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware