STS Industrial - Bolts & Screws

 

FIG 181 ADJUSTABLE STEEL YOKE PIPE ROLL

APPLICATION

The Figure 181 Adjustable Steel Yoke Pipe Roll is designed for the suspension of pipe from a single rod where horizontal movement may occur because of expansion or contraction.

SIZE RANGE

2 1/2″ through 24″

MATERIAL

Cast Iron Roll; Carbon Steel Yoke, Roll Rod and Hex Nuts

MAX TEMP

450° F at Roller

COMPLIANCE

Federal Specification A-A-1192A (Type 43), WW-H-171-E (Type 44), ANSI/MSS-SP-69 and MSS SP-58(Type 44).

NOTE

To order, specify pipe roll size, figure number, name and finish. Be certain to order oversized rolls when insulation and pipe saddles are required.

Fig 181 Adjustable Steel Yoke Pipe Roll

  • INSTALLATION DRAWINGS:

    Fig 181 Adjustable Steel Yoke Pipe Roll Installation Drawing1

    Fig 181 Adjustable Steel Yoke Pipe Roll Installation Drawing 2

  • DIMENSIONS & LOADS:

    Fig 181 Adjustable Steel Yoke Pipe Roll Drawing

    Fig 181 Adjustable Steel Yoke Pipe Roll Loads, Weights, and Dimensions

  • SIZING:
    1. If the roll s to support non-insulated pipe, select the size directly from the nominal pipe size (column 1) in the table under the “Dimensions & Loads” tab.
    2. If used with pipe covering protection saddle, see tables below for size of pipe roll. Choose pipe size in left column, then find the figure number of the saddle to be used, and finally follow the corresponding row right to the “Size of Pipe Roll” data.

    Fig 171 Single Pipe Roll Sizing for Insulated Pipe

     

  • PRODUCT CROSS REFERENCE¹:

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 181

    Carpenter & Paterson Figure 140
    Piping Technology Figure 195
    PHD Figure 470
    B-LINE Figure B3110

    ¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in size and shape. The Product Cross Reference is a guide for the product application only.

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware