STS Industrial - Bolts & Screws

 

FIG 212 MEDIUM PIPE CLAMP

APPLICATION

The Figure 212 Medium Pipe Clamp is recommended for suspension of cold pipe lines or hot lines where no insulation is required. Normally used with Weldless Eyenut Fig. 290, or Welded Eyerod Fig 278. See installation drawings below.

SIZE RANGE

1/2″ through 30″

MATERIAL

Carbon Steel

MAX TEMP

Plain 750° F, Galvanized 450° F

COMPLIANCE

ASME B31.1, Federal Specification A-A-1192A (Type 4), ANSI/MSS-SP-69 (Type 4) and BSPSS-BS3974.

NOTE

The “C” gap dimension ensures adequate clearance at the top attachment point for a weldless eye nut or other appropriate rod attachment. This gap may or may not be present on the bottom portion of the clamp. If different loads or dimensions are required, refer to Fig. 42 SD non-standard two bolt pipe clamp.

Fig 212 Medium Pipe Clamp

  • INSTALLATION DRAWINGS:

    Fig 212 Medium Pipe Clamp Installation Drawing

    Fig 212 Medium Pipe Clamp Installation Drawing

    Fig 212 Medium Pipe Clamp Installation Drawing

    Fig 212 Medium Pipe Clamp Installation Drawing

    The above drawings represent some common installations of the pipe support represented on this page. Installation types and configurations are not limited to the drawings above, but should always follow the manufacturers guidelines for application and installation.

  • DIMENSIONS & LOADS:
    Fig 212 Medium Pipe Clamp Drawing
    Fig 212 Medium Pipe Clamp Loads, Weights, and Dimensions

    Clamps may be furnished with square ends. “Span” represents the maximum recommended distance between hangers on a continuous & straight run of horizontal standard weight steel pipe filled with water. In all cases, verify that chosen location of hangers does not subject hangers to a load greater than the maximum recommended load shown above. For vapor service, the presence of fittings or insulation, and other weights and types of pipe, spans may either increase or decrease. In all cases, verify that chosen location of hanger does not subject hangers to a load greater than the maximum recommended load shown. *Span represents the maximum span for water filled pipe as given in Table 1.

  • PRODUCT CROSS REFERENCE¹:

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 212

    Carpenter & Paterson Figure 175
    Piping Technology Figure 50
    PHD Figure 520
    B-LINE Figure B3140

    ¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in size and shape. The Product Cross Reference is a guide for the product application only.

  • Also Known As

    Two Bolt Pipe Hanger

    Two Piece Pipe Clamp

    Split Pipe Clamp

    Medium Pipe Hanger

    Standard Pipe Clamp

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware