FIG 216 HEAVY PIPE CLAMP
|The Figure 216 Heavy Pipe Clamp is recommended for the suspension of pipe lines where no insulation is required.|
|3″ through 42″|
|Plain 750° F, Galvanized 450° F|
|ASME B31.1, Federal Specification A-A-1192A (Type 4), ANSI/MSS-SP-69 and MSS SP-58 (Type 4).|
|Normally used with welded eye rod or with weldless eye nut Fig 290.Picture to the right is representative of a typical Figure 216. Distance between clamp ears beneath pipe may or may not be equal to upper gap.|
The above drawings represent some common installations of the pipe support represented on this page. Installation types and configurations are not limited to the drawings above, but should always follow the manufacturers guidelines for application and installation.
DIMENSIONS & LOADS:
PRODUCT CROSS REFERENCE¹:
Carpenter & Paterson Figure 298 Piping Technology Figure 60 PHD Figure 522 B-LINE Figure B3142
¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in size and shape. The Product Cross Reference is a guide for the product application only.
Also Known As
Heavy Two Bolt Pipe Hanger
Heany Two Piece Pipe Clamp
Heavy Split Pipe Clamp
Heavy Pipe Hanger
Heavy Pipe Clamp
Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.
Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware