STS Industrial - Bolts & Screws

 

FIG 217 ADJUSTABLE SIDE BEAM CLAMP

APPLICATION

The Figure 217 Adjustable Side Beam Clamp is designed to be used where it is necessary for the hanger rod to run vertically close to the beam edge, eliminating drilling of holes in structural memners.

SIZE RANGE

3″ through 7 5/8″

MATERIAL

Carbon Steel

MAX TEMP

Plain 750° F, Galvanized 450° F

COMPLIANCE

ASME B31.1, Federal Specification A-A-1192A (Type 25). ANSI/MSS SP-69 and MSS SP-58 (Type 25)

NOTE

Components include the top slide, bottom hook, nut and bolt – assembled.

Fig 217 Adjustable Side Beam Clamp

  • DIMENSIONS & LOADS:

    Fig 217 Adjustable Side Beam Clamp Drawing

     

    Fig 217 Adjustable Side Beam Clamp Loads, Weights, and Dimensions

  • PRODUCT CROSS REFERENCE¹:

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 217

    Carpenter & Paterson Figure 18
    Piping Technology
    PHD
    B-LINE Figure B3045

    ¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in size and shape. The Product Cross Reference is a guide for the product application only.

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware