STS Industrial - Bolts & Screws

 

FIG 218 MALLEABLE BEAM CLAMP

APPLICATION

The Figure 218 Malleable Beam Clamp is recommended for attachment to structural beams. Use in applications where beam widths are from 2-3/8″ minimum to 7″ maximum and flange thickness does not exceed 0.60″.Design ensures proper fit for all beam sizes. Tie rod locks clamp in place when nuts are tightened. One universal size. Allows hanger rod to swing from vertical providing flexibility at the beam clamp.

MATERIAL

Malleable Iron jaw. Carbon Steel tie rod, nuts, and washers.

MAX TEMP

Plain 750° F, Galvanized 450° F

COMPLIANCE

ASME B31.1, Federal Specification A-A-1192A (Type 30), WW-H-171-E (Type 30), ANSI/MSS SP-69 and MSS SP-58 (Type 30). UL, ULC Listed (Sizes 3/8″ – 8″ pipe size, when used with the Fig 157 Extension Piece 3/8″ to 7/8″ rod sizes. FM Approved (Sizes 3/4″ – 4″ pipe size, when used with the Fig 157 Extension Piece 3/8″ rod size).

NOTE

The Fig 218 Malleable Beam Clamp may be used with a Fig 278 eye rod, or Fig 157 extension piece.

Fig 218 Malleable Beam Clamp

  • INSTALLATION DRAWINGS:

    Fig 218 Malleable Beam Clamp Installation Drawing 1

    Fig 218 Malleable Beam Clamp Installation Drawing 2

    Fig 218 Malleable Beam Clamp Installation Drawing 3

    The above drawings represent some common installations of the pipe support represented on this page. Installation types and configurations are not limited to the drawings above, but should always follow the manufacturers guidelines for application and installation.

  • DIMENSIONS & LOADS:

    Fig 218 Malleable Beam Clamp Drawing

    Fig 218 Malleable Beam Clamp Loads, Weights, and Dimensions

    *See Table 2 for load capacity of rod.

  • PRODUCT CROSS REFERENCE¹:

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 218

    Carpenter & Paterson Figure 82
    Piping Technology Figure 135
    PHD Figure 630
    B-LINE Figure B3054

    ¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in size and shape. The Product Cross Reference is a guide for the product application only.

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware