STS Industrial - Bolts & Screws

 

FIG 227 TOP BEAM CLAMP

APPLICATION

The Figure 227 Top Beam Clamp is recommended for use on top flange of beam and roof trusses where the flange thickness does not exceed 0.81″.

MATERIAL

Carbon Steel Jaw, Hook Rod with Nut, lock washer and plain washer.

COMPLIANCE

ASME B31.1, Federal Specification A-A-1192A (Type 25),ANSI/MSS-SP-69 and MSS SP-58 (Type 25). UL Listed (rod sizes 3/8″ and 1/2″) and FM Approved when used with 3/8″ rod.

NOTE

Determine hook rod length by adding figure in column headed “x” to flange width (see table on page 207 for flange width). “x” is not indicated as a dimension on drawing.

Slide stamped steel jaw over beam flange and attach hook rod and eye rod, finally tightening hook rod. Hammer jaw firmly against the underside of the beam to complete installation.

Two jaw sizes fit beam flanges thickness from 0.25″ to 0.81″. Clamp firmly holds to beam providing safe and extremely economical means of supporting small piping from the top flange of steel beams and roof trusses.

Fig 227 Top Beam Clamp

  • DIMENSIONS & LOADS:

    Fig 227 Top Beam Clamp Drawing

    Fig 227 Top Beam Clamp Loads, Weights, and Dimensions

     

  • PRODUCT CROSS REFERENCE¹:

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 227

    Carpenter & Paterson
    Piping Technology
    PHD
    B-LINE Figure B3042

    ¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in size and shape. The Product Cross Reference is a guide for the product application only.

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware