STS Industrial - Bolts & Screws

 

FIG 228 UNIVERSAL FORGED BEAM CLAMP WITH UFS (UPPER) RIGHT HAND NUT

APPLICATION

The Figure 228 Beam Clamp with Right Hand Nut is intended for the suspension of heavy loads from beams with flange widths to 15″ and flange thickness to 1.031″. Upper nut is tapped to any specified size up to the maximum rod diameter. Quickly, easily, economically installed. Tie rod ensures non-slip fit to beam.

MATERIAL

Forged Steel

MAX TEMP

Plain 750° F, Galvanized 450° F

COMPLIANCE

ASME B31.1, Federal Specification A-A-1192A (Type 28 without links; Type 20 with links), WW-H-171-E (Type 30 & 31), ANSI/MSS SP-69 and MSS SP-58 (Type 28 without links; Type 29 with links).

NOTE

The application of a load to a structural beam by means of a beam clamp produces a transverse stress, perpendicular to the axis of the beam, in the flange to which the load is applied.

Fig 228 Forged Beam Clamp

  • INSTALLATION DRAWINGS:

    Fig 228 Forged Beam Clamp Drawing 3

    Fig 228 Forged Beam Clamp Drawing 1

    Fig 228 Forged Beam Clamp Drawing 2

    The above drawings represent some common installations of the pipe support represented on this page. Installation types and configurations are not limited to the drawings above, but should always follow the manufacturers guidelines for application and installation.

  • DIMENSIONS & LOADS:

    Fig 228 Forged Beam Clamp Without Links Drawing

    Fig 228 Forged Beam Clamp Loads, Weights, and Dimensions

    Fig 228 Forged Beam Clamp With Links Drawing

    Fig 228 Forged Beam Clamp Sizing

  • PRODUCT CROSS REFERENCE¹:

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 228

    Carpenter & Paterson Figure 293
    Piping Technology Figure 135
    PHD
    B-LINE

    ¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in size and shape. The Product Cross Reference is a guide for the product application only.

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware