STS Industrial - Bolts & Screws

 

FIG 230 TURNBUCKLE

APPLICATION

The Figure 230 Turnbuckle connects one right hand threaded item and one left habd threaded item allowing for up to 6″ or 12″ of adjustment depending on size.

SIZE RANGE

3/8″ through 2-1/2″

MATERIAL

Forged Steel

FINISH

Plain or Galvanized

COMPLIANCE

Federal Specification A-A-1192A (Type 13), WW-H-171-E (Type 13), ANSI/MSS-SP-69 and MSS SP-58 (Type 13).

Fig 230 Turnbuckle

  • INSTALLATION DRAWINGS:

    Fig 230 Turnbuckle Installation Drawing 1

    Fig 230 Turnbuckle Installation Drawing

    The above drawings represent some common installations of the pipe support represented on this page. Installation types and configurations are not limited to the drawings above, but should always follow the manufacturers guidelines for application and installation.

  • DIMENSIONS & LOADS:

    Fig 230 Turnbuckle Drawing

    Fig 230 Turnbuckle Loads, Weights, and Dimensions

  • PRODUCT CROSS REFERENCE¹:

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 230

    Carpenter & Paterson Figure 132
    Piping Technology Figure 30
    PHD Figure 960
    B-LINE Figure B3202

    ¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in size and shape. The Product Cross Reference is a guide for the product application only.

  • Also Known As

    Turnbuckle Body

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware