STS Industrial - Bolts & Screws

 

FIG 260 ISS CLEVIS HANGER WITH INSULATION SADDLE SYSTEM

APPLICATION

The Figure 260 ISS Clevis Hanger with Insulation Saddle System is recommended for the suspension of stationary insulated chilled or hot water pipe lines.

SIZE RANGE

1/2″ through 30″

MATERIAL

Carbon Steel, Plain or Galvanized

MAX TEMP

40° F to 200° F

COMPLIANCE

The 260 ISS has been independently tested by ASTM & UL for flame spread (FSI), smoke development (SD) and drip ratings. The product has been approved by both agencies and has qualified for an ASTM E84 Class 125/60 rating, as well as a UL E94 VO rating which are the highest rating for this type of product by either agency.

NOTE

Clevis hanger with high impact saddle eliminates costly hanger adjustments required during the installation of piping insulation. Wood blocks and shields are not required for use with this product. V-Block design cradles the pipe during and after installation. Low thermal conductivity calculated at 0.77 (BTU-in/Sq. Ft-Hr-°F). Flammability rating of V-O UL 94.

Fig 260 ISS Clevis Hanger with Insulation Saddle System

  • DIMENSIONS & LOADS:

    Fig 260 ISS Clevis Hanger with Insulation Saddle System Drawing

    Fig 260 ISS Clevis Hanger with Insulation Saddle System Sizing Chart

    .

    Fig 260 ISS Clevis Hanger with Insulation Saddle System Loads, Weights, and Dimensions

  • INSTALLATION:

    Hanger load nut above clevis must be tightened securely to assure proper performance. Install the pipe on the saddle. Cope or notch one section of insulation to securely fit around the saddle. Notch should be deep enough to extend 1/8″ to 1/4″ beyond the saddle. Square cut adjoining insulation section and butt the mating end to the notched section. Apply mastic to all mating insulation edges, caulk all seams between insulation and saddle as applicable to chilled or hot water systems to assure positive vapor barrier. Finish via standard taping methods.

    ADJUSTMENT:

    Vertical adjustment without removing the hanger may be made 7/8″ through 23/8″ varying with the size of the clevis. Tighten all nuts after adjustment.

  • PRODUCT CROSS REFERENCE¹:

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 260 ISS

    Carpenter & Paterson
    Piping Technology
    PHD
    B-LINE

    ¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in size and shape. The Product Cross Reference is a guide for the product application only.

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware