STS Industrial - Bolts & Screws

 

FIG 277: PIPE ROLL WITH CAST IRON BASE PLATE

FIG 277S: PIPE ROLL WITH STEEL BASE PLATE

APPLICATION

The Figure 277 and Figure 277S Pipe Roll with Base Plate are recommended as an economical means of supporting pipe where small longitudinal movement due to expansion and contraction may occur and where no vertical adjustment is required.

The Figure 277 Pipe Roll is supplied with a cast iron base plate. The Figure 277S is supplied with a steel base plate.

SIZE RANGE

2″ through 24″

MATERIAL

Cast Iron Roll; Cast Iron or Steel Base Plate

Plain or Galvanized

MAX TEMP

450° F at Roller

COMPLIANCE

ASME B31.1, Federal Specification A-A-1192A (Type 45), WW-H-171-E (Type 46), ANSI/MSS-SP-69 and MSS SP-58 (Type 45).

NOTE

Installation consists of setting unit in place. Weight of pipe and material hold unit in place.

Fabricated carbon steel base plates for extended travel are available.

Fig 277, Fig 277S Pipe Roll and Base Plate

  • DIMENSIONS & LOADS:

    Fig 277, Fig 277S Pipe Roll and Base Plate Drawing

    Fig 277, Fig 277S Pipe Roll and Base Plate Loads, Weights, and Dimensions

  • SIZING:
    1. If the roll s to support non-insulated pipe, select the size directly from the nominal pipe size (column 1) in the table under the “Dimensions & Loads” tab.
    2. If roll is to support covered pipe, the O.D. of the covering should not be greater than the O.D of the pipe for which the roll was designed.
    3. If used with pipe covering protection saddle, see tables below for size of pipe roll. Choose pipe size in left column, then find the figure number of the saddle to be used, and finally follow the corresponding row right to the “Size of Pipe Roll” data.
    ORDERING:
    • Specify pipe roll size.
    • Order should include figure number, name and finish in all cases.
    • Be certain to order oversized rolls when insulation and protection saddles make it necessary.

    Fig 171 Single Pipe Roll Sizing for Insulated Pipe

     

  • PRODUCT CROSS REFERENCE¹:

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 277

    Carpenter & Paterson Figure 63
    Piping Technology Figure 240
    PHD
    B-LINE Figure B3119SL

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 277S

    Carpenter & Paterson
    Piping Technology
    PHD
    B-LINE Figure B3119L Base

    ¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in material, size, or shape. The Product Cross Reference is a guide for the product application only.

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware