STS Industrial - Bolts & Screws

 

FIG 292 UNIVERSAL FORGED STEEL BEAM CLAMP

APPLICATION

The Figure 292 is designed for the suspension of heavy loads from beams with flange widths to 15″ and flange thickness to 1.031″.

MATERIAL

Forged Steel

COMPLIANCE

ASME B31.1, Federal Specification A-A-1192A (Type 28 without links, Type 29 with links),WW-H-171-E (Type 28 without links, Type 29 with links), ANSI/MSS-SP-69 and MSS SP-58 (Type 28 without links, Type 29 with links).

NOTE

Fit jaws over edges of lower beam flanges and tighten nuts on tie rod to lock clamp in place. Weldless eye nut provides for horizontal pipe movement without binding, and is furnished tapped to any specific rod size up to the maximum rod size.Tie rod assures a tight non-slip fit to the beam.The application of a load to a structural beam by means of a beam clamp produces a transverse stress, perpendicular to the axis of the beam, in the flange to which the load is applied.

Fig 292-292L

  • INSTALLATION DRAWINGS:

    Fig 292 292L Beam Clamp with Eye Nut Drawing 1

    Fig 292 292L Beam Clamp with Eye Nut Drawing 2

    Fig 292 292L Beam Clamp with Eye Nut Drawing 3

    The above drawings represent some common installations of the pipe support represented on this page. Installation types and configurations are not limited to the drawings above, but should always follow the manufacturers guidelines for application and installation.

  • DIMENSIONS & LOADS:

    Fig 292 292L Beam Clamp with Eye Nut

    Fig 292 292L Beam Clamp with Eye Nut Loads, Weights, and Dimensions

  • PRODUCT CROSS REFERENCE¹:

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 292

    Carpenter & Paterson Figure 297
    Piping Technology Figure 135
    PHD
    B-LINE Figure B3291-B3298

    ¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in size and shape. The Product Cross Reference is a guide for the product application only.

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware