STS Industrial - Bolts & Screws

 

FIG 295 DOUBLE BOLT PIPE CLAMP

APPLICATION

The Figure 295 Double Bolt Pipe Clamp is recommended for suspension of pipe requiring insulation within the limitation of temperature and loads shown below.

SIZE RANGE

3/4″ through 36″

MATERIAL

Carbon Steel

MAX TEMP

Plain 750° F, Galvanized 450° F

COMPLIANCE

ASME B31.1, Federal Specification A-A-1192A (Type 3), WW-H-171-E (Type 3), ANSI/MSS-SP-69 and MSS SP-58 (Type 3).

NOTE

Attach to the clamp may be made with a welded eye rod Fig 278, or the weldless eye nut Fig 290. Sizes 6″ and above accommodate up to 4″ thick insulation.The picture to the right is representative of a typical Figure 295. Distance between clamp ears beneath pipe may or may not be equal to upper gap.

Fig 295 Double Bolt Pipe Clamp

  • INSTALLATION DRAWINGS:

    Fig 295 Double Bolt Pipe Clamp Installation Drawing 1

    Fig 295 Double Bolt Pipe Clamp Installation Drawing 2

    Fig 295 Double Bolt Pipe Clamp Installation Drawing 3

    Fig 295 Double Bolt Pipe Clamp Installation Drawing 4

    The above drawings represent some common installations of the pipe support represented on this page. Installation types and configurations are not limited to the drawings above, but should always follow the manufacturers guidelines for application and installation.

  • DIMENSIONS & LOADS:

    Fig 295 Double Bolt Pipe Clamp Drawing

    Fig 295 Double Bolt Pipe Clamp Loads, Weights, and Dimensions

    Clamps may be furnished with square ends. “Span” represents the maximum recommended distance between hangers on a continuous & straight run of horizontal standard weight steel pipe filled with water. In all cases, verify that chosen location of hangers does not subject hangers to a load greater than the maximum recommended load shown above. For vapor service, the presence of fittings or insulation, and other weights and types of pipe, spans may either increase or decrease. In all cases, verify that chosen location of hanger does not subject hangers to a load greater than the maximum recommended load shown. *Span represents the maximum span for water filled pipe as given in Table 1.

  • PRODUCT CROSS REFERENCE¹:

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 295

    Carpenter & Paterson Figure 304
    Piping Technology Figure 70
    PHD Figure 525
    B-LINE Figure B3144

    ¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in size and shape. The Product Cross Reference is a guide for the product application only.

  • Also Known As

    Insulated Pipe Hanger

    Two Piece Double Bolt Pipe Clamp

    Split Double Bolt Pipe Clamp

    Standard Pipe Clamp for Insulated Pipe

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware