STS Industrial - Bolts & Screws

 

FIG 300 ELONGATED CLEVIS HANGER

APPLICATION

The Figure 300 Elongated Clevis Hanger is recommended for the suspension of insulated stationary pipe lines. Hanger load nut above clevis must be tightened securely to assure proper hanger performance. Vertical adjustment without removing pipe may be made. Amount of adjustment varies with the size of clevis. Tighten upper nut after adjustment.

SIZE RANGE

3/4″ through 12″

MATERIAL

Carbon Steel

MAX TEMP

Plain 750° F, Galvanized 450° F

COMPLIANCE

ASME B31.1, Federal Specification A-A-1192A Type 1, MSS-SP-58 Type 1, and BSPSS-BS3974.

NOTE

  • Designed for 2″ of insulation on 3/4″ through 1-1/2″ pipe and 4″ of insulation on 2″ and larger pipe.
  • When properly installed, clevis bolt is outside the insulation. 

Fig 300 Elongated Clevis Hanger

  • DIMENSIONS & LOADS:

    Fig 300 Elongated Clevis Hanger Drawing

     

    Fig 300 Elongated Clevis Hanger Loads, Weights, and Dimensions

  • PRODUCT CROSS REFERENCE¹:

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 300

    Carpenter & Paterson Figure 100EL
    Piping Technology Figure 89
    PHD Figure 430
    B-LINE Figure B3108

    ¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in size and shape. The Product Cross Reference is a guide for the product application only.

  • Also Known As

    Adjustable Clevis for Insulated Lines

    Elongated Saddle Clamp

    Elongated Stirrup Hanger

    Saddle Clamp for Insulated Lines

    Stirrup Hanger for Insulated Lines

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware