STS Industrial - Bolts & Screws

 

FIG 40 STANDARD RISER CLAMP

APPLICATION

The Figure 40 Standard Riser Clamp is used for the support of vertical piping. Load is carried by shear lugs which are welded to the pipe.

SIZE RANGE

1/2″ through 30″

MATERIAL

Carbon Steel

MAX TEMP

Plain 750° F, Galvanized 450° F

COMPLIANCE

ASME B31.1, Federal Specification A-A-1192A Type 4,MSS-SP-69 Type 4 and BSPSS-BS3974.

NOTE

If different loads or dimensions are required, use Fig. 40 SD special design riser clamp.

Fig 40 Standard Riser Clamp

  • INSTALLATION DRAWINGS:

    Fig 40 Standard Riser Clamp Installation Drawing

     

     

    The above drawings represent some common installations of the pipe support represented on this page. Installation types and configurations are not limited to the drawings above, but should always follow the manufacturers guidelines for application and installation.

  • DIMENSIONS & LOADS:

    Fig 40 Standard Riser Clamp Drawing

    Fig 40 Standard Riser Clamp Loads, Weights, and Dimensions

  • PRODUCT CROSS REFERENCE¹:

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 40

    Carpenter & Paterson Figure 124
    Piping Technology Figure 190
    PHD
    B-LINE

    ¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in size and shape. The Product Cross Reference is a guide for the product application only.

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware