STS Industrial - Bolts & Screws

Fig 50 Angle Trapeze Technical Data

 

FIG 50 EQUAL LEG ANGLE FOR TRAPEZE ASSEMBLY

APPLICATION

The Figure 50 Equal Leg Angle for Trapeze Assembly is to be suspended by two rods and is designed for top loading exclusively. 

MATERIAL

Carbon Steel

ORDERING

If two holes “H” are required (nominal size, C to C, H, total weight and load). If two holes “H” and “D” are required (nominal size, B, C to C, D, E, H, total weight and load). If two holes “H” and two holes “J” are required (nominal size, C to C, H, J, K, M, total weight and load)

Fig 50 Angle Trapeze Assembly

  • DIMENSIONS & LOADS:

    Fig 50 Angle Trapeze Assembly Drawing

    Fig 50 Angle Trapeze Assembly Loads, Weights, and Dimensions+

  • Fig 50 Angle Trapeze Assembly Installation Drawing

  • PRODUCT CROSS REFERENCE¹:

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 50

    Carpenter & Paterson Figure 374
    Piping Technology
    PHD
    B-LINE

    ¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in size and shape. The Product Cross Reference is a guide for the product application only.

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware