STS Industrial - Bolts & Screws

 

FIG 590 ADJUSTABLE CLEVIS FOR DUCTILE OR CAST IRON PIPE

APPLICATION

The Figure 590 Adjustable Clevis Hanger  is recommended for the suspension of stationary ductile iron or cast iron pipe.

SIZE RANGE

4″ through 24″

MATERIAL

Carbon Steel

FINISH

Plain or Galvanized

COMPLIANCE

ASME B31.1, Federal Specification A-A-1192A (Type 1), WW-H-171-E (Type 1), ANSI/MSS SP-69 and MSS SP-58 (Type 1).

NOTE

Hanger rod nut above clevis must be tightened securely to assure proper hanger performance. Vertical adjustment without removing pipe may be made from 1 5/16″ through 3 3/16″, varying with the size of the clevis. Tighten upper nut after adjustment.

Figure 590 sizes 12″ and belowe typically feature a Figure 260 top component.

Fig 590 Adjustable Clevis Hanger for Ductile or Cast Iron Pipe

  • DIMENSIONS & LOADS:

    Fig 590 Adjustable Clevis Hanger for Ductile or Cast Iron Pipe Drawing

    Fig 590 Adjustable Clevis Hanger for Ductile or Cast Iron Pipe Loads, Weights, and Dimensions

  • PRODUCT CROSS REFERENCE¹:

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 590

    Carpenter & Paterson Figure 100CI
    Piping Technology
    PHD Figure 420
    B-LINE Figure B3102

    ¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in size and shape. The Product Cross Reference is a guide for the product application only.

  • Also Known As

    Saddle Clamp for Ductile or Cast Iron Pipe

    Stirrup Hanger for Ductile or Cast Iron Pipe 

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware