STS Industrial - Bolts & Screws

 

FIG 67 PIPE OR CONDUIT HANGER

APPLICATION

The Figure 67 Pipe or Conduit Hanger can be suspended by a hanger rod or attached to a vertical member via bolt through the provided hole. “T” slot in hanger permits side bolt to be installed after installation and setting of pipe.

SIZE RANGE

1/2″ through 6″

MATERIAL

Carbon Steel

MAX TEMP

Galvanized 450° F

COMPLIANCE

ASME B31.1, Federal Specification A-A-1192A (Type 5), ANSI/MSS SP-69 and MSS SP-58 (Type 5).

NOTE

Strap and bolt with nut – assembled.

Fig 67 Pipe or Conduit Hanger

  • DIMENSIONS & LOADS:

    Fig 67 Pipe or Conduit Hanger Drawings

    Fig 67 Pipe or Conduit Hanger Loads, Weights, and Dimensions

  • PRODUCT CROSS REFERENCE¹:

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 67

    Carpenter & Paterson
    Piping Technology
    PHD Figure 970
    B-LINE Figure B3690

    ¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in size and shape. The Product Cross Reference is a guide for the product application only.

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware