STS Industrial - Bolts & Screws

 

FIG 69 ADJUSTABLE SWIVEL RING

APPLICATION

The Figure 69 Adjustable Swivel Ring is recommended for the suspension of non-insulated stationary pipe.

SIZE RANGE

1/2″ through 8″

MATERIAL

Carbon Steel

MAX TEMP

Galvanized 450° F

COMPLIANCE

ASME B31.1, Federal Specification A-A-1192A Type 10,WW-H-171-E Type 10, ANSI/MSS-SP-69 and MSS SP-58 Type 10. UL Listed and FM Approved (Sizes 3/4″ – 8″)

NOTE

Threads are countersunk so that they cannot become burred or damaged. Knurled swivel nut provides vertical adjustment after piping is in place. Captured swivel nut in the 1/2″ through 6″ sizes. The capture is permanent in the bottom of the band, allowing the hanger to be opened during installation if desired, but not allowing the nut to fall completely out.

Fig 69 Adjustable Swivel Ring

  • INSTALLATION DRAWINGS:

    Fig 69 Adjustable Swivel Ring Installation Drawing 1

    Fig 69 Adjustable Swivel Ring Installation Drawing 2

    Fig 69 Adjustable Swivel Ring Installation Drawing 3

    Fig 69 Adjustable Swivel Ring Installation Drawing 4

    The above drawings represent some common installations of the pipe support represented on this page. Installation types and configurations are not limited to the drawings above, but should always follow the manufacturers guidelines for application and installation.

  • DIMENSIONS & LOADS:

    Fig 69 Adjustable Swivel Ring Drawing

    Fig 69 Adjustable Swivel Ring Loads, Weights, and Dimensions

    Note: Reflects changes in rod diameter from previously published data per recent revisions in MSS-SP58 & 69

  • PRODUCT CROSS REFERENCE¹:

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 69

    Carpenter & Paterson Figure 800
    Piping Technology Figure 2
    PHD Figure 141
    B-LINE Figure B3170NF

    ¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in size and shape. The Product Cross Reference is a guide for the product application only.

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware