STS Industrial - Bolts & Screws

 

FIG 86 C-CLAMP WITH SET SCREW AND LOCK NUT

FIG 87 C-CLAMP WITH SET SCREW AND FIG 89 RETAINING CLIP

FIG 88 C-CLAMP WITH SET SCREW ONLY

APPLICATION

The Figure 86, 87 and 88 C-Clamps are recommended for attachment to “W” and “M” beams where thickness of flange does not exceed 0.75″. When clamp is used with Fig 89 retaining clip, flange thickness may not exceed 0.62″.

SIZE RANGE

3/8″ through 3/4″

MATERIAL

Malleable Iron Clamp, Hardened Steel Cup Point Set Screw

COMPLIANCE

ASME B31.1, Federal Specification A-A-1192A (Type 23), WW-H-171-E (Type 23), ANSI/MSS-SP-69 (Type 23). UL, ULC Listed (Sizes 3/8″ through 3/4″) and FM Approved (Sizes 3/8″).

NOTE

Follow recommended set screw torque values per MSS-SP-69. The Fig 88 is only to be used on installations where the clamp cannot become dislodged from the beam.

Malleable body assures uniform quality and strength and full thread engagement. Hardened steel cup point set screw for securing to beam flange. Ribbed design of clamp provides added strength.

Fig 86

  • INSTALLATION DRAWINGS:

    Fig 86 87 88 C-Clamp Installation Drawing

    The above drawings represent some common installations of the pipe support represented on this page. Installation types and configurations are not limited to the drawings above, but should always follow the manufacturers guidelines for application and installation.

  • DIMENSIONS & LOADS:

    Fig 86 87 88 C-Clamp Drawing

    Fig 86 87 88 C-Clamp Loads, Weights, and Dimensions

  • PRODUCT CROSS REFERENCE¹:

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 86

    Carpenter & Paterson Figure 196
    Piping Technology
    PHD Figure 270
    B-LINE Figure B3036L

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 87

    Carpenter & Paterson
    Piping Technology
    PHD Figure 270-I w/259
    B-LINE Figure B3036 w/B3363

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 88

    Carpenter & Paterson
    Piping Technology
    PHD Figure 270-I
    B-LINE Figure B3036

    ¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in size and shape. The Product Cross Reference is a guide for the product application only.

  • Also Known As

    Malleable C Clamp

    C Clamp with Set Screw

    C Clamp with Retaining Clip

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware