STS Industrial - Bolts & Screws

 

FIG 92 UNIVERSAL C-CLAMP (WIDE THROAT)

APPLICATION

The Figure 93 Universal C Type Clamp with Wide Throat is recommended for use under roof installations with bar joist type construction, or for the attachment to the top or bottom flange of structural shapes where the vertical hanger rod is required to be offset from the edge of the flange and where the thickness of joist or flange does not exceed 1 1/4″.

SIZE RANGE

3/8″ and 1/2″

MATERIAL

Malleable/Ductile Iron Clamp, Hardened Steel Cup Point Set Screw and Lock Nut.

FINISH

Plain or Galvanized

COMPLIANCE

ASME B31.1, Federal Specification A-A-1192A (Type 19 and 23), WW-H-171E-E (Type 23), ANSI/MSS-SP-69 and MSS SP-58 (Type 19 and 23). UL, ULC Listed and FM Approved.

NOTE

They may be attached to horizontal flanges of structural members in either the top beam or bottom beam positions. Secured in place by a cup point set screw tightened against the flange. Through tapping of the body casting permits extended adjustment of the threaded rod. Wider throat for attaching to flange with up to 1 1/4″ thickness.Follow recommended set screw torque values.

Fig 93 Universal Wide C-Clamp

  • INSTALLATION DRAWINGS:

    Fig 92 Universal C-Clamp Installaion Drawing 2

    Fig 92 Universal C-Clamp Installaion Drawing 1

    Fig 92 Universal C-Clamp Installaion Drawing 3

    Fig 92 Universal C-Clamp Installaion Drawing 4

    The above drawings represent some common installations of the pipe support represented on this page. Installation types and configurations are not limited to the drawings above, but should always follow the manufacturers guidelines for application and installation.

  • DIMENSIONS & LOADS:

    Fig 92 Universal C-Clamp Drawing

    Fig 93 Universal Wide C-Clamp Loads, Weights, and Dimensions

  • PRODUCT CROSS REFERENCE¹:

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 93

    Carpenter & Paterson
    Piping Technology
    PHD Figure 360
    B-LINE Figure B3033

    ¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in size and shape. The Product Cross Reference is a guide for the product application only.

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware