STS Industrial - Bolts & Screws

 

FIG 95 C-CLAMP WITH LOCK NUT

APPLICATION

The Figure 95 C Clamp with Lock Nut is designed for fastening to flange of “W” and “M” beam. Bottom hole tapped to accommodate hanger rod.

SIZE RANGE

3/8″ and 1/2″

MATERIAL

Carbon Steel

FINISH

Plain or Galvanized

COMPLIANCE

ASME B31.1, Federal Specification A-A-1192A (Type 23), WW-H-171E-E (Type 23), ANSI/MSS-SP-69 and MSS SP-58 (Type 23). UL Listed (3/8″) and FM Approved (Sizes 3/8″ – 1/2″).

NOTE

If retaining clip is desired, either the fig 89X or fig 89 may be specified. Follow recommended set screw torque values.

Fig 95 C-Clamp with Lock Nut

  • DIMENSIONS & LOADS:

    Fig 95 C-Clamp with Lock Nut Drawing

    Fig 95 C-Clamp with Lock Nut Loads, Weights, and Dimensions

  • PRODUCT CROSS REFERENCE¹:

    MANUFACTURER

    FIGURE NUMBER

    Anvil International

    Figure 95

    Carpenter & Paterson Figure 47
    Piping Technology
    PHD Figure 250
    B-LINE Figure B351L

    ¹Product loads, weights, and dimensions may vary from manufacturer to manufacturer. Products may not be identical in size and shape. The Product Cross Reference is a guide for the product application only.

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware