STS Industrial - Bolts & Screws

 

FIG 98 AND C-98 DOUBLE SPRING VARIABLE SPRING HANGERS

RECOMMENDED SERVICE:

The Figure 98 Variable Spring Hanger, or Spring Can, is recommended for support applications that are subject to vertical thermal movement and for which a constant support hanger is not required. Type D & E spring hangers may accommodate less than 4° of rod swing depending on size, figure number, and application. The Variable Double Spring Hanger, Fig. 98, embodies all of the Fig. B-268 features and is designed to the same exacting specifications. Each basic unit consists of two springs arranged in series within a single casing. A centering guide is provided to assure the permanent alignment of the spring assembly.

DESIGN FEATURES:
  • Precompression: Precompressing the spring into the hanger casing provides the following advantages:
    • Saves up to 50% in headroom by reducing the length of the hanger.
    • Reduces the installed height of the overall hanger assembly.
    • Prevents the spring supporting force from exceeding the normal safe limits of variations.
    • Saves valuable erection time because spring is precompressed close to 1⁄2″ of the working range.
  • Calibration: All Variable Spring Hangers and supports are calibrated for accurate loading conditions.
  • Load indicator is clearly seen in the slot, simplifying reading of the scale plate. Load is read from bottom of indicator.
  • Cold set at the factory upon request.
  • Spring and casing are fabricated of steel and are rugged and compact.
  • Piston cap serves as a centering device or guide maintaining spring alignment.
  • Casing protects the spring from damage and weather conditions.
FINISHES:

Standard Finish: Painted with a semi-gloss primer, Figure 98.

Corrosion Resistant: Corrosion-resistant and weather resistant Spring Cans are available to fill vital needs in the chemical and refinery industries as well as in modern outdoor power plant construction. For protection against severe weather conditions or moderate corrosive conditions, the parts of the hanger are galvanized per ASTM A-153, except the spring which has a protective coating and the load column for Type F which is electro-galvanized. Corrosion resistant finish denoted by a “C” before the figure number (i.e. Figure C-98).

  • Protects from a wide range of corrosives.
  • Does not affect the flex life of the spring.
  • Recommended for ambient temperatures up to 200° F.
SIZE RANGE:

The Variable Spring Hanger in five series and seven types is offered on 23 sizes (B-268 is offered in 25 sizes). The hanger can be furnished to take loads from 10 lbs to 10,000 lbs.

COMPLIANCE:

WW-H-171E (Types 51, 56, and 57), ANSI/MSS SP-69 and MSS SP-58 (Types 51, 52, and 53). Variable Spring Hangers are welded in accordance with ASME Section K.

HANGER TYPES:

Click on the images below for detailed specifications.

 TYPE F

Fig 98 Type F Spring Can

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: Anvil International Pipe Hangers and Supports, Carpenter and Paterson Pipe Support Hardware