STS Industrial - Bolts & Screws

 

STANDON MODEL S92 PIPE SADDLE SUPPORT

APPLICATION

The Standon Model #S92 Pipe Saddle Support is designed to support a horizontal, ductile iron pipe line via a saddle below the pipe. A neoprene liner is available to accommodate IPS sized pipe. A nearly 50% circumferential cradle, and a pipe to saddle gap of less than 0.125″ ensures excellent performance. User supplies desired length of schedule 40 pipe to insert between the upper collar and lower base cup. Vertical adjustment is attained through the use of threaded rod in the upper collar to which the flange bracket is attached.

SIZE RANGE

2″ through 36″

MATERIAL

Saddle Stap: ASTM A36, Collar/Base Cups: ASTM A53 D.O.M Tubing, Threaded Stud: ASTM A307 Rolled Thread, Base Plate: ASTM A36 Sheet Steel – 0.25″ Plate, Optional: 100% 304 Stainless Steel

FINISH

Electro-Galvanized (unless Stainless), Optional Finishes Available

FABRICATION

All Welds: 100% MIG Welded- Electrode E70XX, Saddle: Formed to Ductile Iron Pipe Radius, Plates: Laser Cut, Radiused Corners

NOTE

Collar and base cup accept standard IPS pipe, no threading is required.

Standon Model S92 Adjustable Pipe Saddle Support

  • SPECIFICATIONS:

    Standon Model S92 Saddle Pipe Support Specifications

  • INSTALLATION INSTRUCTIONS:

    Measure Distance from pipe to floor.

    1. Measure distance from bottom of supported pipe to finish floor elevation.

    Cut Sch. 40 pipe 4" shorter.

    2. Cut a piece of schedule 40 pipe 4″ less than the previously measured distance.

    Thread collar onto stud of saddle and insert Sch. 40 pipe into collar and base.

    3. Thread the collar assembly all the way onto the stud of the saddle assembly, then assemble the lower portion of the completed support including the cut pipe pipe section and position under the pipe.

    Turn collar counter-clockwise to tighten.

    4. Turn the collar assembly counter-clockwise until the saddle fits snugly under the pipe. Insure that the base assembly is positioned directly under piping system. Base may be secured to the floor with 1/2″ wedge anchors if required.

Note: All material included on this page is informational only, and should not be used as one’s sole source for design purposes. STS Industrial, Inc. and its affiliates do not guarantee the accuracy of the information on this site, and retain no liability for the use or misuse of the information contained on this site.

Sources: standon.net